KENWOOD RSE7
Instrukcja Obsługi

30

Recording
R-SE7/DP-SE7/X-SE7 (En)

To repeat a recording
Return to the recording start position. Press the rewind key during recording.
During recording of reverse side (while 2 is lit)
1 ¡

÷ If there is a non-recorded space of more than 4 seconds before the recording start position, recording is aborted and tape is rewound as shown below. Tape stops after 2 sec. of transport. Recorded tune Tune to be re-recorded Re-recording Blank of 4 sec. or more ÷ If there is no recorded tune before, the tape will be rewound then stopped.

During recording of top side (while 3 is lit)

Automatic Adjustment of the Recording Level (CRLS)
A standard recording level has been set in advance for the cassette deck (X-SE7), but when the CRLS function is used, the max. recording level is set automatically for the music source. 1 Play the contents to be recorded If the key has never been pressed (or receive the radio station to be recorded). 2 Press the CRLS key.
.....The sound is recorded with the basic level set with the unit.

If the key is pressed
.....The recording level is set automatically and stored in memory as the recording level to be used with the current input being selected. From the next time on, this recording level is set automatically for that input even if the key is not pressed.

To return to the basic level
.....Hold the key depressed until the indicator goes off (for approx. 3 seconds).
CRLS

About 20 sec
CRLS CRLS

÷ The recording level setting completes in approx. 20 seconds, after which the deck enters the record-pause mode. ÷ If recording is started during the setting (while the CRLS indicator is blinking), distorted sound may be recorded. ÷ If a non-recorded space of more than 3 seconds is detected after the CRLS key is pressed, the recording level setting is aborted.

Points for Recording from a CD or an MD

For recording from a CD or an MD, playback from

the music source and recording by the cassette deck can be started simultaneously (synchro recording function) when the cassette deck is set to record pause status in advance.

1 Pause the CD or MD to be played. 2 Use the skip keys (4 ¢) to select the title to be recorded. (Pause will be reached at the beginning of the selected title.) 3 Bring the cassette deck to recording pause condition. 4 Start playback of the CD or MD. (Synchro recording will start.)
÷ The recording is stopped when the stop key of the playback unit is pressed.

Knowledge sections Application Basic Preparation section

Dolby HX Pro
The Dolby HX Pro headroom extension system records high frequencies such as the cymbal sound clearly by controlling the bias current during recording according to the frequency composition of the sound being recorded. This system is activated automatically during recording with this unit.