Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
VOLUME, SOUND MODE AND OTHER CONTROLS
VOLUME buttons
+ : Use to increase the volume. � : Use to decrease the volume. (Control range from VOL 0 to VOL 50.)
Main unit
VOLUME
Sound mode button
Sound modes can be selected to enhance the type of music being played. ÷ Press the SOUND button to select the sound mode. ÷ Each time the SOUND button is pressed the sound mode changes as follows:
Main unit
SOUND
Remote control unit
Remote control unit
VOLUME
SOUND
AHB (Active Hyper Bass*) PRO button
BASS 1: The AHB PRO indicator lights up, and a mild bass boost is added to the sound. BASS 2: The AHB PRO indicator lights up, and a stronger bass boost is added to the sound. OFF : The AHB PRO indicator goes out. Set to this position when Active Hyper Bass Pro sound is not required. ÷ The factory-preset is �FLAT�. Each time the SOUND button is pressed, the display changes as shown.
* Active Hyper Bass (AHB) Pro The Active Hyper Bass Pro circuit reinforces the bass sound to maintain rich, full bass at low volumes (playback only).
Main unit
AHB PRO
Remote control unit
AHB PRO
Sound mode selection LIVE: Set to this position for heavy metal or rock music. POP: Set to this position for light music including popular and vocal music. CLEAR: Set to this position for crisp and clear sounding music with transparent highs. FLAT (No sound effect (flat characteristics)): Set to this position when listening to classical music. Note: The selected modes only affect the sound output from the speakers or headphones. They do not affect the sound when recording.
AHB PRO
AHB PRO indicator lights in red when AHB PRO is set to BASS 1/BASS 2.
SPEAKER ILLUMINATION/ACS (Active Clear Sound*) button
Press this button to turn enhanced sound reproduction ON/OFF. When on, a light in each speaker flashes. * Active Clear Sound (ACS) The Active Clear Sound (ACS) circuit emphasizes high-frequency sound without lowering the signal-noise ratio, while adjusting its output according to the input signal level. This results in a better balance between the high-frequency sound and the low-frequency heavy bass sound. Note: This fuction has no effect with monaural sound sources.
Main unit
SPEAKER ILLUMINATION /ACS
