|
|
|
Kto jest w sklepie?
Sklep przegląda 5768 gości i
2 zarejestrowanych klientów |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
RV-DP200BK
<CD Unit >
Prior to performing the following procedure, remove the front cabinet, the rear cabinet and the CD unit.
CN419 CN418 Main Switch board CN410 CN417
Removing the main switch board and illumination boad. (See Fig.22)
1. Disconnect the card wire from connector CN411 and CN412, and the harness from CN401,CN419 and CN410 of the main switch board on the underside of the CD unit. 2. Remove the four screws R attaching the main switch board and illumination board.
R
CN413
R
CN411 CN412
CN415
R
Illumination board
R
CD unit Fig.22
CN401
Removing the micon board
(See Fig.23)
Prior to performing the following procedure, remove the main switch board. CAUTION: Prior to disconnecting the card wire from connector CN601 on the micom board, solder the short-circuit land on the pickup unit. Disconnecting the card wire extending from the pickup unit may cause damage to the pickup unit. When reassembling, unsolder the short-circuit land on the pickup unit after connecting the card wire to connector CN601. Fig.25 shows more detail about the short-circuit land.
CN602
S
CN601
S
CN412
(Disconnect after soldering the short-circuit land.)
d
CN911 CN916 CN422
S
S
Micom board
CN912
Fig.23
1. Disconnect the card wires from connector CN601 and CN911 on the micon board. 2. Remove the spacer fixing the harnesses marked d. 3. Remove the four screws S attaching the micon board. 4. Disconnect the harness from connector CN912 and CN602 on under side of the micon board respectively.
1-11
|
|
|
> |
|
