JVC RX6022VSL
Instrukcja Serwisowa

RX-6022VSL

Removing the audio board

(See Fig.9)
Relay board power supply board CN473 CN291 Power transformer Power / Fuse board

Prior to performing the following procedure, remove the top cover and the rear panel. 1. Disconnect the card wire from connector CN402 on the audio board. 2. Disconnect the relay board from the audio board and the power supply board. (CN291, CN491) 3. Disconnect the harness from connector CN471, CN472, CN473. 4. Remove the three screws G attaching the audio board assembly. 5. Remove the screw H attaching the audio board assembly.

G
CN402

G
Audio board CN471 CN472

G

CN491

H

Fig.9

I I J I
Main board

CN241

Removing the main board

(See Fig.10)

Prior to performing the following procedure, remove the top cover, the rear panel and audio board. 1. Disconnect the harness from connector CN241 and CN203 on the power supply board respectively. 2. Disconnect the harness from connector CN251 on the power transformer board. 3. Remove the four screws I and the two screws J attaching the main board.

J
CN251

CN203

I

Fig.10

Removing the Heat sink (See Fig.11 to 13)
Prior to performing the following procedure, remove the top cover and main board. 1. Remove the two screws K attaching the heat sink to the reverse side of main board. 2. Disconnect the for connectors with each amp. board, and remove the main board.

K

K

Fig.11

Main board rear side

Front Rch amp. board Heat sink Front Lch amp. board Center amp. board

3. Remove the four screws M and ten screws L Rear Lch amp. board attaching the heat sink. Rear Rch amp. board

Heat sink

L

L

L M

Main board

M

CN802 CN801 CN302 CN301

CN901

Fig.13

Fig.12

1-6