Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
RX-6000VBK/RX-6008VBK/RX-6100VBK
Removing the regulator board / the rear -Rch amplifier board (See Fig.10 and 11)
Prior to performing the following procedure, remove the top cover. 1. Disconnect the harness from connector CN831 on Volume control the main board. board
CN512 Main board CN511 Regulator board Tie band Tie band
Main board CN831
Tie band
2. Remove the two screws H attaching the regulator board to the heat sink. 3. Disconnect the harness from connector CN511 on the main board and CN512 on the volume control board. Cut off the three tie bands fixing the harnesses. 4. Remove the two screws I attaching the rear-Rch amplifier board to the heat sink.
Rear-Rch amplifier board
Fig.10
Regulator board Rear-Rch amplifier board
H
I
Removing the main board (See Fig.12 and 13)
Prior to performing the following procedure, remove the top cover, the rear panel, the relay board and the preamplifier board. 1. Disconnect the card wire from connector CN811 on the main board. 2. Unsolder each harness connecting the power transformer and the main board. 3. Unsolder the power cord on the main board. 4. Remove the eight screws J board to the heat sink. 5. Remove the eight screws K board. attaching the main
Heat sink
Fig.11
K
Main board CN811 Speaker switch board
K
Soldered part
FW902 Power transformer
K
Main board
K J
Soldered part
Fig.12
J
Heat sink
attaching the main
6. For the harness extending from the speaker switch board, unsolder FW902 on the main board.
