jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
RX-7001PGD Removing the power supply board (See Fig.18 and 19)
Prior to performing the following procedure, remove the top cover and the front panel. 1. Remove the one nut attaching the headphone jack of the power supply board on the front side of the body. 2. Disconnect the relay board 1, 2 and 3 from the power supply board and the main board respectively. 3. Disconnect the harness connected to connector CN55 and CN56 on the power transformer board (If necessary, cut off the band fixing the harness on the side of the base chassis). 4. Remove the four screws O attaching the power supply board and pull out the power supply board from the front bracket backward. 5. Unsolder the three harnesses connected to the Relay board 2 power supply board.
Power supply board Nut Headphone jack
Fig.18
Power supply board Headphone jack Relay board 1
O
Solder
O
Solder
O
Tie band CN55 CN56 Tie band
Removing the system control board / power switch board (See Fig.20 to 21)
Prior to performing the following procedure, remove the top cover and the front panel assembly. 1. Pull out the volume knob on the front side of the front panel and remove the nut attaching the system control board. 2. Remove the six screws P attaching the system control board on the back of the front panel and disconnect the harness from connector CN422 on the system control board. 3. Disconnect the harness from connector CN430 on the power switch board.
