JVC RX-7001PGDUS
Instrukcja Obsługi

English

5. Press TEST again to stop the test tone. 6. Press EFFECT to select an effect level you want.
� Each time you press the button, the effect level changes as follows:

TEST

4
EFFECT

Activating the DSP Modes
You can use only one DSP mode at a time. When a DSP mode is activated, another DSP mode is canceled if in use.

7/P

DSP EFFECT 1

DSP EFFECT 2

DSP EFFECT 3

For Dolby Pro Logic, Dolby Digital, DTS Digital Surround and MPEG Multichannel

DSP EFFECT 5

DSP EFFECT 4

As the number increases, JVC Theater Surround becomes stronger.

1. Press SURROUND ON/OFF so that the lamp on the front panel button lights up.
� Each time you press the button, the Dolby/DTS/MPEG Surround turns on and off alternately.
SURROUND ON/OFF
SURROUND ON/OFF

On the front panel: You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.

On the front panel

On the remote control

1. Press DSP MODE repeatedly until �THEATER� appears on the display.
The Ÿ PRO LOGIC and DSP indicators also light up on the display.

DSP MODE

2. Select and play a sound source.
� To enjoy Dolby Pro Logic, play back a software encoded with Dolby Surround and labeled with DOLBY SURROUND mark. � To enjoy Dolby Digital, play back a software encoded with Dolby Digital and labeled with mark. � To enjoy DTS Digital Surround, play back a software encoded with DTS Digital Surround and labeled with mark. � To enjoy MPEG Multichannel, play back a software encoded with MPEG Multichannel and labeled with mark.
DIGITAL

2. Adjust the speaker output levels.
1) Press (BALANCE/) SURROUND ADJUST repeatedly until one of the indications appears on the display. �CENTER LEVEL�: To adjust the center speaker level. �REAR L LEVEL�: To adjust the left rear speaker level. �REAR R LEVEL�: To adjust the right rear speaker level. 2) Turn MULTI JOG to adjust the selected speaker output level (from �10 dB to +10 dB). 3) Repeat 1) and 2) to adjust the other speaker output levels.

BALANCE/SURROUND ADJUST

To cancel the Dolby/DTS/MPEG Surround mode
Press SURROUND ON/OFF again so that the lamp on the front panel button goes off. (�SURROUND OFF� appears on the display.)
MULTI JOG

SURROUND ON/OFF
SURROUND ON/OFF

3. Adjust the effect level.
1) Press (BALANCE/) SURROUND ADJUST repeatedly until �DSP EFFECT� appears on the display. The display changes to show the current setting. 2) Turn MULTI JOG to select the effect level. As you turn it, the effect level changes as follows:
BALANCE/SURROUND ADJUST

On the front panel

On the remote control

MULTI JOG

DSP EFFECT 1

DSP EFFECT 2

DSP EFFECT 3

DSP EFFECT 5

DSP EFFECT 4

As the number increases, JVC Theater Surround becomes stronger.

27