Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 43 (kliknij aby zobaczyć)
5. Adjust the speaker output levels as follows: � To adjust the center speaker level, press CNTR +/�. � To adjust the left rear speaker level, press REAR�L +/�. � To adjust the right rear speaker level, press REAR�R +/�.
ENTER
CNTR
MENU
2
REAR L
3
REAR R
Notes:
� You can adjust the speaker output levels and center tone
5
6
8
9
6. Press TEST again to stop the test tone.
TEST
4
7. Press CNTR TONE to select the center tone level you want. The center tone adjustment affects the mid-frequency range, which the human voice is mostly made up of. Each time you press the button, the display changes to show the following: SOFT2 SOFT1 FLAT SHARP1
CNTR TONE
without outputting the test tone. � You cannot adjust the center speaker level when �CENTER SPK� is set to �NONE� (see page 20). � You cannot adjust the rear speaker levels when �REAR SPK� is set to �NONE� (see page 20).
Note:
The center tone cannot be adjusted when �CENTER SPK� is set to �NONE� (see page 20).
1
SHARP2
Adjusted level are also shown on the on the equalizer display.
This CNTR means this adjustment can be applied to the center speaker only. (Example: When �FLAT� is selected.)
SEA
CNTR
100
1k
10k
To make the dialogue clearer, select �SHARP1� (little) or �SHARP2� (much). To make the dialogue softer, select �SOFT1� (little) or �SOFT2� (much). When �FLAT� is selected, no adjustment is applied. 8. Press EFFECT to select the effect level. Each time you press the button, the effect level changes as follows: DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3
EFFECT
Note:
You cannot adjust the effect level when �REAR SPK� is set to �NONE� (see page 20).
7/P
DSP EFFECT 5
DSP EFFECT 4
As the number increases, the surround effect becomes stronger.
To cancel the Theater Surround mode Press SURROUND MODE repeatedly until �OFF� appears. The DSP and THEATER indicators goes off.
