Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
Other speaker setup options (Center speaker only)
� Attaching to a wall
[Note]
�The wall or pillar on which the speakers are to be attached should be capable of supporting 10 kg (22 Ib.) per screw. Consult a qualified building contractor when attaching the speakers to wall. Improper attachment may result in damage to the wall and speakers. �Do not attempt to attach these speakers to walls using methods other than those described in this manual.
1
Drive a screw (not included) into a wall.
30�35 mm (13/16q�13/8q) �7.5�9.4 mm (19/64q� 3/8q) Wall or pillar 8�11 mm (3/8q� 7/16q)
2
Fit the speaker securely onto the screws with the holes.
117.5 mm (411/16q)
So that the speaker fits up against the wall squarely, be sure to press the speaker cable down into the groove.
In this position, the speaker will likely fall if moved to the left or right.
Move the speaker so the screw is in this position.
� Fitting speaker stands (not included)
Ensure the stands meet these conditions before purchasing them. Observe the diameter and length of the screws and the distance between screws as shown in the diagram. �The stands must be able to support over 10 kg (22 lb.). �The stands must be stable even if the speakers are in a high position.
5 mm (13/64q), pitch 0.8 mm (1/32q) 60 mm (223/64q)
Speaker stand (not included)
Attach the stands with these holes.
Plate thickness plus 7 to 10 mm (plus 9/32q to 25/64q)
