PANASONIC SAHT933
Instrukcja Obsługi

4

Connect the speaker cables.
Rear of the speaker

� Preventing the speakers from falling over
Preparation Attach screw eyes (not included) to secure the speakers to the wall (� diagram below). �You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened. �Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers. To prevent the speaker from falling over, thread the string (not

Twist off the vinyl tips of the speaker cables. �If the speaker cables do not have vinyl tips, directly connect them to the terminals.

_: Copper `: Silver
Push ! Press the speaker cable into the groove.

included) from the wall to the speaker as shown and tie tightly.

[HT730] [HT733]

Screw eye (not included) String (not included)

If there is any excess speaker cable, thread the speaker cable into the opening near the top of the pipe while pulling the speaker cable from the bottom of the base.

Rear of the speaker Wall

Approx. 150 mm (5 29/32z)

5

Fasten the speaker cable to the base.

[HT930]

Screw eye (not included) String (not included)

�Using the same polyfoam as in procedure 2 will assist you in safely and securely fastening the speaker cables.

2 Fit the speaker 1 Press the speaker
cable and thread between the hooks. cable into the base cover groove as far as possible. Rear of the speaker Wall Approx. 150 mm (5 29/32z)

Rear side of base

Cable Screw eye (not included) [HT933] String (not included)

Rear of the speaker

Wall

Approx. 150 mm (5 29/32z)

RQT7972

7

Front speaker assembly