Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 3 (kliknij aby zobaczyć)
SA-WP16 SECTION 1 DIAGRAMS
� NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary note is printed in each block.) For schematic diagrams.
Note: � All capacitors are in µF unless otherwise noted. (p: pF) 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1/4 W or less unless otherwise specified. � C : panel designation. Note: The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. � A : B+ Line. � B : B� Line. � Voltages and waveforms are dc with respect to ground under no-signal (detuned) conditions. no mark : Power on � : Impossible to measure � Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. � Signal path. F : AUDIO � Abbreviation E51: Chilean and Peruvian model
Ver. 1.1
1-1. CIRCUIT BOARDS LOCATION
INPUT CONTROL board SWITCH board MAIN board
For printed wiring boards.
Note: � X : parts extracted from the component side. � a : Through hole. � : Pattern from the side which enables seeing. � Indication of transistor.
