PHILIPS SBCRU430/02D
Instrukcja Obsługi

RU240- page 4

3 Immediately press

to stop the search.

English

If you missed the correct code because the search went too far, switch the equipment back on, then press P (down) to send the previous code again. Press P (down) repeatedly until the equipment switches off again. 4 Once you've found the correct code, press The green LED blinks twice. to lock it in memory.

That's it! Now, switch the equipment manually on again, then press a few keys on the remote to check that the equipment responds correctly. In the rare instance that it doesn't, try again from step 1 to find a better code. Note that code! To save time if you ever need to setup again, make a note of the correct code inside the battery case and in the back of this booklet. In case you have forgotten to note the code you can still 'read out' the code from the remote. Here's how: 1 Make sure you've selected the right mode (with ). Then press and release 1 and 6 at the same time; the green LED lights up. 2 Press . The green LED goes out. 3 Press 1 and count the number of times the green LED blinks. This is the first digit of the 3-digit code. (No blinks means the digit is zero.) Press 2 and count the number of blinks for the second digit. Press
3

and count the number of blinks for the third digit.

ADVANCED TIPS AND TRICKS TO CHANGE SAT MODE TO CONTROL A SECOND TV The SAT mode on this remote is used to control additional equipment. It is factory preset to control a satellite receiver, but you can change it to control a second TV, for example. Before you start, press to select SAT, and make sure the second TV is switched on. 1 Press and hold 1 and 6 at the same time -for about 3 secondsuntil the green LED lights up. 2 On the keypad, enter 992. 3 Press to select TV mode, then press any key except once more. That's it! Don't forget you now need to setup the remote to operate this second TV - see Getting started. TO CONTROL THE SECOND TV'S VOLUME If you have installed a second TV under SAT mode, you can also control that TV's volume when you are in VCR mode. Before you start, press 1 Press and hold 1 and to select VCR. at the same time until the green LED

6

lights up (about 3 seconds). 4