1 Make sure the Parent Unit is connected to the TV and the Camera Unit is connected to the Baby Unit.The Parent Unit should be placed in its docking base. 2 Switch on the Baby Unit by pressing POWER (1). > The SYSTEM check light (3) lights green.
SYSTEM
SYSTEM
ON VOLUME OFF ON VOLUME OFF
3 Switch on the Parent Unit by turning the ON VOLUME OFF control (16) to ON. Observe the clicking sound. > The SYSTEM check light (15) lights green. 4 Switch on your TV and select the External Input (·). Note:The Parent Unit must remain in the docking base otherwise the signal from the Baby Unit is interrupted. In this case you will receive no picture on the TV screen.
Adjusting loudspeaker volume of the Parent Unit
� Adjust the volume level of the Parent Unit to the preferred level using the ON VOLUME OFF control (16).
Checking that the units have contact
� Check that the SYSTEM check light (15) on the Parent Unit lights continuously green to confirm that both units have contact. > The SYSTEM check light (15) lights/flashes red and the system check alarm on the Parent Unit beeps when: - the units are not in touch; - out of range; - there is interference.
