PANASONIC SB-TP10
Instrukcja Obsługi

SB-FS702 SB-FS802 SB-FS702 SB-FS802 100 mm SB-PC702 SB-PC802 SB-FS702 SB-FS802 5 mm Pitch 0.8 mm 60 mm SB-FS702 SB-FS802

SB-PC702 SB-PC802 SB-FS702 SB-FS802 SB-WA54 30°30° SB-WA55

SB-PC702 SB-PC802

;; ;; ;;
Speaker setup

30-35 mm ø7.5-9.5 mm 7-9 mm

SB-FS702 SB-FS802

120°

SB-FS702 SB-FS802

Location
Front speakers ( , ) Put on either side of the television. Center speaker ( ) Put above or below the center of the television, on a shelf or rack or attach to the wall. Placing it directly on the television can cause the picture to be distorted. Surround speakers ( , ) Put to the side of or slightly behind the seating area, about one meter higher than ear level. Subwoofer( ) Place anywhere as long as it is a reasonable distance from the television. Place it at least 5 cm from the wall as it has a bass reflex port in the rear. The front, center, and surround speakers should be placed at approximately the same distance from the listening position. The angles in the diagram are approximate. How you set up your speakers can affect the bass and the sound field. Note the following points. �Place on flat, level secure bases. Use spacers or a similar item to stop them from rocking. �Placing speakers too close to floors, walls, and corners can result in excessive bass. �Cover walls and windows with thick curtain. �Do not place anything on top of the subwoofer.

SB-FS702 or SB-FS802 These speakers are the same. Use them as front or surround speakers. SB-PC702 / SB-PC802 Use as the center speaker.

Before attaching to a wall or speaker stand
SB-FS702 / SB-PC702 / SB-FS802 / SB-PC802 Unscrew the screw to remove the stand.

Attaching to the wall
SB-FS702 / SB-PC702 / SB-FS802 / SB-PC802 Screw (not included) Screw the wood screw into a thick and hard part of the wall. The surface you attach the speakers to must be able to support over 10 kg.

Attaching to speaker stands
SB-FS702 / SB-FS802 Speaker stands (not included) Plate thickness + 7 to 10 mm Attach the stands with these holes. Ensure the following conditions are met when you purchase your speaker stands. �Observe the diameter and length of the screws and the distance between screws as shown in the diagram. Screw; diameter: 5 mm, pitch: 0.8 mm, length: thickness of stand plate plus between 7 and 10 mm. Distance between the centers of the holes: 60 mm �The stands must be able to support over 10 kg. �The stands must be stable even if the speakers are in a high position.

Do not attach these speakers to walls or ceilings using methods other than those described here.

3
RQT6901