Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 43 (kliknij aby zobaczyć)
KEX-M8886ZT ,M8886ZT-91
5. Details 1 Frequency characteristics adjustment function � The system changes submodes cyclically every time the [FM1/2] button is pressed when "AUDIO" is displayed. Set EQ Point 1 ¨ Set EQ Point 2 ¨ Set attenuation ¨ "AUDIO" � Set EQ Point 1 The system displays �P1� and EQ management number. The EQ management number ascends/descends every time the UP/DOWN button is pressed.The EQ management number consists of three digits (000 to 286). Initial value is 000 (no setting). � Set EQ Point 2 The system displays �P2� and EQ management number. The EQ management number ascends/descends every time the UP/DOWN button is pressed. The EQ management number consists of three digits (000 to 176). Initial value is 000 (no setting). � Set attenuation The system displays �L� and attenuation value. Use the UP/DOWN button to change attenuation within a range from 0 to -20 dB at increments of 1 dB. Attenuation value is shown in two digits from 00 to 20 (20 = -20 dB). Initial value is 00 (no setting). 2 level adjustment function � The system changes submodes cyclically every time the [TAPE] button is pressed when "AUDIO" is displayed. Set front ¨ Set rear ¨ Set woofer ¨ �AUDIO� � Set front The system displays "F" and level value.Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting). � Set rear The system displays "R" and level value. Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting).
� Set woofer The system displays "W" and level value. Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting). Notes: 1) Pressing the TAPE button during adjustment of frequency characteristics is invalid. Pressing the [FM1/2] button during level adjustment is invalid. 2) The UP/DOWN button mentioned above means the [SEEK] (UP,DOWN) key. Filter 1 : ATT of 30 to 35 dB for receiving frequency Filter 2 : ATT of 5 to 10 dB for receiving frequency The filter should not cause the switch to be set to OPEN when the filter is ON. If setting the switch to OPEN cannot be avoided, duration
