PHILIPS SCN2CARD
Instrukcja Obsługi

SCAN 2

10/3/00

10:49 AM

Page 24

ON-SCREEN MENU CONTROLS

TV PICTURE SETUP MENU

S

canCard II has two different operation modes; Consumer and Commercial. When in the Consumer mode, all available menu items and tuning options are fully enabled (with the exception of the COMMERCIAL SETTING menu). Access to ScanCard II�s internal �TV PICTURE SETUP,� �VGA PICTURE SETUP,� and the TV�s �SETUP� menus can be selected with the supplied ScanCard II remote control. When in the Commercial mode, limited menu access can be obtained. Only the �TV PICTURE SETUP,� and �VGA PICTURE SETUP� menus are accessible with the supplied ScanCard II remote control.

W

hen viewing normal broadcast channels only the BRIGHTNESS and PICTURE controls can be changed, or the TV can be restored to its PRESETS (RESTORE PRESETS). This menu can be accessed by the MENU or ADJUST buttons on the remote.
TV PICTURE SETUP BRIGHTNESS - - - - - - - - - PICTURE ---------RESTORE PRESETS EXIT MENU PRESS + OR � TO CHANGE TV PICTURE SETUP BRIGHTNESS - - - - - - - - - PICTURE ---------RESTORE PRESETS EXIT MENU PRESS + OR � TO CHANGE

Adjust BRIGHTNESS using the + or � buttons.
TV PICTURE SETUP

Adjust PICTURE using the + or � buttons.
TV PICTURE SETUP BRIGHTNESS - - - - - - - - - PICTURE ---------RESTORE PRESETS EXIT MENU PRESS + OR - TO EXIT

PICTURE ADJUSTMENTS

BRIGHTNESS - - - - - - - - - PICTURE ---------RESTORE PRESETS EXIT MENU

Y

ou can make some adjustments to the TV picture using the TV PICTURE SETUP or the VGA PICTURE SETUP on-screen menu. Follow the steps below for the proper procedure.
BEGIN

PRESS + TO RESTORE

RESTORE PRESETS using the + button.

EXIT the menu using the + or - buttons.

TV PICTURE SETUP DESCRIPTIONS
Brightness Control - Press the (+) or (-) button to adjust the brightness to the desired level. The (+) button increases the picture BRIGHTNESS while the (-) button will decrease the picture BRIGHTNESS. Picture Control - Press the (+) or (-) button to adjust the picture quality. This controls the pictures clarity and contrast. Restore Presets - Pressing the (+) button will restore the menu options back to the preset options set by the setup technician. Exit Menu - Press the (+) or (-) button to clear the onscreen menu from the picture.

Press the SELECT (M) button on the remote control to see the on-screen menu. Press the MENU wv on the remote control repeatedly to move the highlight to the desired feature to change or adjust. Press the MENU buttons on the remote control to adjust or change the highlighted feature. Press the STATUS/EXIT button on the remote control to clear the screen when finished.

24

25