|
|
|
Kto jest w sklepie?
Sklep przegląda 5699 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
1-3-4. Sub Chassis (with a pickup mechanism) 1. Turn the mechanism chassis assembly (1) upside down. 2. Remove one screw (2) and release the boss �A� from the claw. Then remove the sub chassis (3) (with the pickup mechanism) by sliding in the arrow direction. 3. When mounting, perform the reverse order of the removal. Note: � When mounting the sub chassis (3) (with the pickup mechanism), first, insert the boss �C� along the groove of the cam slider up/down cam (4) and next, the boss �B� and �A�. � The boss �A� may be used with washers. (One or two washers are used to prevent from the slust rattling. In some cases, no washer is used.) When the washer(s) is used, be sure to assemble as it was without losing.
Screw (2) Sub chassis (3) (with the pickup mechanism attached) Boss C
1-3-5. Pickup Mechanism Assembly <Removal> 1. Remove four screws (1) and then remove the pickup mechanism assembly (2). <Mounting> 1. Replace the pickup mechanism assembly (2) with a new one. 2. When mounting, perform the reverse order of the removal.
Screw (1)
Damper (Black) Damper (Blue)
Damper (Black)
Boss A
Damper (Blue) Pickup mechanism assembly (2)
Washers Boss B
Cam slider up/down cam (4)
Groove
Fig. 2-1-17 Note:
Mechanism chassis assembly (1)
Claw
Groove Boss A
� The dampers� color differs when used for the front side and the rear. � When mounting the pickup mechanism assembly (2) with the screws (1), push the pickup mechanism assembly (2) downward without being caught and tighten the screws (1).
Screw (1)
Claw Boss B Groove
Damper Pickup mechanism assembly (2)
Fig. 2-1-16
Fig. 2-1-18
|
|
|
> |
|
