|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
1
2
3
4
7.1.2 Disassembly 7 Transmitter
A
1. Remove the two screws of the stand. 2. Remove the four screws of the lower case. 3. Slide the cover of the upper and lower cases. 4. Remove the lower case. 5. Remove the soldering from the charge terminal. 6. Remove the three fixing screws of the phono jack. 7. Remove the Board Assy from the upper case with the VR control attached.
B
Board Assy
7 Headphones
C
<L side> 1. Remove the ear pad. 2. Remove the three screws of the base and remove the base. 3. Remove the two screws of the base cover and remove the base cover. 4. Remove the soldering from the lead wire on the photo board. 5. Remove the screw of the board.
POWER BOARD Assy
6. Remove the photo cover.
D
PHOTO BOARD Assy
<R side> 1. Remove the ear pad. 2. Remove the three screws of the base and remove the base. 3. Remove the two screws of the base cover and remove the base cover. 4. Remove the soldering from the lead wire on the photo board. 5. Remove the screw of the board.
E
MAIN BOARD Assy
6. Remove the photo cover.
PHOTO BOARD Assy
F
32
1 2
SE-DIR800C
3 4
|
