|
|
|
Kto jest w sklepie?
Sklep przegląda 5901 gości i
2 zarejestrowanych klientów |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
1
2
3
4
A
CS Assy ( Surround and Center ) The grille assy is attached to the cabinet by 4 external screws. To detach it, unfasten those screws. When attaching it, it attaches, as the connection cord is under the speaker unit. ( Surround ) The grille assy is attached to the cabinet by 8 external screws. To detach it, unfasten those screws. When attaching it, it attaches, as the connection cord is under the speaker unit. ( Center ) The speaker unit is attached to the grille by 4 internal screws. To detach it, first remove the grille assy. Next unfasten those screws, and remove the cable. When attaching it, face its terminal leftward. (See to the backside of the grille assy.)
CS Assy ( Subwoofer ) The cosmetic baffle is attached to the cabinet by its bosses. To detach it, pry it open by inserting a flat blade screw driver into lower slot. To attach it, clean the press-fitting part and apply a bit of adhesive . Then press it to the bafle. (Fig. 2) The passive radiator is attached to the baffle by 4 external screws. To detach it, first remove the cosmetic baffle. Then remove the passive radiator. When attaching it, face its the rib for input terminal board toward the vertical direction. The woofer is attached to the back board of cabinet by 4 external screws. To detach it, unfasten those screws. When attaching it, face its terminal upward. The input terminal is attached to the back board by press-fitting and glue. To detach it, pry it open by inserting a flat blade screwdriver into the lower side. When attaching it, the red terminal is right-side.
B
apply adhesive
apply adhesive
C
Fig. 2
D
E
F
2
1 2
S-EV1000V
3 4
|
|
|
> |
|
