SHARP SF2118
Instrukcja Serwisowa

3 Rotate the mirror base B counterclockwise to remove. 4 Disconnect the connector from the copy lamp unit on the rear
frame side and from the No. 2/3 mirror unit. 5 Rotate the No. 2/3 mirror unit counterclockwise and remove.

1 Hook the metal fixture of the mirror base wire on the optical base
plate hook.

2 Pass the mirror base wire along the groove outside the double
pulley. <Note> At the time, put the No. 2/3 mirror unit on the mirror base positioning plate. Hold it so that the winding pulley groove is on the upper side, and wind the wire.

4 Pass it under the moving pulley supporting plate and wind it
around the fixed pulley.

3

5 Pass it along the groove inside the double pulley. 6 Pass in through the L pulley. 7 Hook the mirror base wire spring on the groove at the left of the

1

2

optical base plate. (Same in the front and the rear side.)

2
D. No. 2/3 mirror unit (mirror base B) assembly
Reverse the above procedures.

4 6

5

E. Mirror base wire stretching
Check that the wire groove in the front winding pulley is aligned with the wire groove in the rear winding pulley. (If there is too much a shift in the circumference, loosen two pulley fixing screws, and visually fit the positions and fix.

3 2
1

5 4 6

7

a

F. Mirror base wire fixing 1 Manually turn the mirror base drive pulley to bring the mirror base
B into contact with the mirror base positioning plate.

2 Shift the 9th winding tip of the mirror base wire from the pulley
screw hole section.

1

Mirror base B

6�9