Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 29 (kliknij aby zobaczyć)
USING THE SELF-CLEANING CYCLE
SETTING THE CONTROLS (CONT.)
To delay the start using delay start time:
1. Press the auto clean pad.
This will automatically set a 31�2-hour Self-Cleaning cycle. NOTE: There will be a 30-minute cool-down 1�2 hour before the cycle is over.
PRESS
AUTO CLEAN
YOU SEE
CLEAN TIME
2. Set the cleaning time (optional).
If you want a Self-Cleaning cycle longer or shorter than 31�2 hours, use the Hour and Minute pads to set the cleaning time you want. Press the �up� (s) or �down� (t) pad(s) until a time between 21�2-41�2 hours shows on the display. � Use 21�2 hours for light soil. � Use 31�2-41�2 hours for average to heavy soil.
PRESS
HR MIN
YOU SEE
CLEAN TIME
(example for 41�2-hour cycle)
3. Press the delay start time pad.
PRESS
DELAY START TIME
YOU SEE
START
CLEAN TIME
4. Set the start time.
Press the �up� (s) or �down� (t) pad(s) until the correct time shows on the display. The oven will automatically come up with the stop time by adding the set cleaning time to the set start time.
PRESS
HR MIN
YOU SEE
START
CLEAN TIME
(example for 2:30 start time)
5. Press the start/enter pad.
PRESS
START
ENTER
YOU SEE
DELAY
ON
CLEAN
5 SEC
6. After the Self-Cleaning cycle starts:
The door will lock as soon as you press the start/ enter pad.
YOU SEE
HEAT TIMED
ON
LOCKED CLEAN TIME
7. After the Self-Cleaning cycle ends:
LOCKED goes off and the door unlocks. NOTE: The stop time will be the start time plus the cleaning time.
