|
|
|
Kto jest w sklepie?
Sklep przegląda 5687 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
SF-S54N
6. Mount the connection unit.
Fix the roller unit to the connection unit, using a securing screw (1 pc.). Next, cut off the cutting portion ( ) of the support guide with a nipper, then fix it to the connection unit with securing screws (2 pcs.).
Roller unit securing screw Roller unit
Before carrying out the procedures below, insert the copier�s power plug into its outlet, and turn the main power switch ON.
8. Set the mode.
�
Set the mode with key operation on the copier.
C 0 2 6
Connection unit Cut
0
1
Adding system: Enter a numeric value using the 10-key pad which is obtained by adding the numbers shown below that correspond to the options to be mounted.
Support guide securing screw Cut Support guide Support guide securing screw
RADF/ADF: 1
DESK: 4
SORTER: 10
Example: If the ADF and sorter are mounted: enter 11 (1 + 10 = 11).
The mode can be set with this operation.
Insert the connection unit�s lower tabs (2) into the tab slots inside the back of the sorter. Next, insert the upper tabs (2) into their tab slots to install the connection unit.
Perform stapler-sorter function checks.
1. Check sort mode functioning.
Make 10 copies in the sort mode. Check that the sorter deposits the copies in the sort bins.
Tab (lower) Tab (upper)
2. Check non-sort mode functioning.
Make copies in the non-sort mode. Check that copies are deposited in the non-sort bin.
3. Check staple-sort mode functioning.
Make copies in the staple-sort mode. Check that copies are deposited in the sort bins, that the staple guide bar aligns the copies and that the staple unit staples them. If copies are not stapled, follow the procedure below to make the staples emerge correctly.
Tab (lower) Tab (upper)
Connection unit
If copies are not stapled:
7. Connect the sorter connector.
Remove the securing screw of sorter connector cover attached to the rear cabinet of copier main body, and detach the sorter connector cover. Connect the sorter connector to the copier main body connector, and fix it with the sorter connector securing screw.
Sorter connector cover
1. Remove the staple cartridge.
Open the sorter front cover. Push up the stapler unit�s cartridge release lever, and remove the staple cartridge from the stapler unit.
Securing screw
2. Close the sorter front cover, and remove the paper.
After removing the staple cartridge, close the sorter front cover. Next, remove all the paper from the sort bins.
Sorter connector
2/2/1999
�3�
|
|
|
> |
|
