Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 24 (kliknij aby zobaczyć)
Microphone sensitivity of the SKM 5200 and the SKM 5000:
SKM 5200: Setting in dB SKM 5000: Switch position �40 1 �30 2 �20 3 �10 4 0 5
Adjusting the low-cut frequency � LOWCUT
To reduce unwanted low-frequency noise such as engine, wind and rumble noise, you can activate a low-cut filter. The low-cut frequency can be set to 190 Hz or 120 Hz. If you do not want to reduce low-frequency signal portions, select the setting �FLAT�.
Selecting the standard display � VIEW
Via the �VIEW� menu, you can select one of the following standard displays:
RF
RF
RF
CH
MHz
CH CH
Transmission frequency �FREQ�
Channel �CHAN�
Name �NAME�
The selected standard display is shown after switch-on, after the menu settings have been displayed in display mode.
Loading the factory-preset default settings � RESET
Via the �RESET� menu, you can load the factory-preset default settings. After the reset, the standard display is shown on the display panel. Low-cut frequency flat Microphone sensitivity �20 dB Name 5200 Standard display frequency Autolock function deactivated Channel FIX 01 Frequencies in the channel bank �VAR� are reset
