PANASONIC SLCT790
Instrukcja Obsługi

Sequential Play

Basic Play

1
EQ MODE MEMORY

2
OPEN
S L

R

L

3
0
P

HOLD
Remote control

T A

BL

E

L PA

Y

HOLD

C T 7 9

HOLD

Label must face upward. Press near the center so the disc clicks firmly into place.

O PEN
HOLD

CHG

VOL

Close the lid.

Plug type: 3.5 mm (1/8 in.) stereo
O R

4
C D

E R

Remote control
(Beep)

5
Remote control

MODE

MEMORY

VOL
Decrease Increase
MODE

(Beep)

Increase

MEMORY

Track number in play

(Beep)

Decrease
S-XBS

Elapsed playing time of each track

VOL

S-XBS

Follow steps 1�5.
In step 2: Connect the stereo headphones/earphones and wired remote control to the headphone jack [�]. (Plug in firmly.) In step 5: �The volume range is 0-25. (Press and hold to change the volume successively.) In step 5: �The volume changes when pressed while the level is displayed. If any other display is shown, it changes to show the current level. (The volume returns to 10 when you disconnect the power source.) Note! �Play stops automatically when all the tracks have been played. �If the unit has been connected to the car audio system, set this unit�s volume to 10, then adjust the volume level on the system.

Resume function
The player stores the track where you stopped play and if you press [1/;] (main unit) or [1/�] (remote control), play resumes from the beginning of that track. Note! �Opening the lid while in the stop mode or replacing the disc while in the off mode cancels the function. (It may remain active if you replace a disc in the off mode.) �Play may resume from the beginning of the next track if you stopped play near the end of a track. �The resume function is automatic and you cannot turn it off.

Removing discs
1 Press [�] to stop play and disc rotation. 2 Slide [OPEN] to open the lid. 3 Once the disc has stopped, lift the disc out with your finger in the depression.
Do not stop the disc by hand or try to remove it before it stops rotating. This can damage CDs.

Depression

For your reference: �)� indication
This indication appears for about 30 seconds if [1/;] (main unit) or [1/�] (remote control) is pressed when no disc is loaded in the unit or if the disc is not properly secured. Note! Never insert foreign objects into the unit.

Auto-off function
If you leave the unit in stop mode for about 10 minutes, (30 seconds if a disc is not loaded) it turns off to save the batteries.

�*� indication
This indication appears for about 10 minutes when the lid is opened. (However, the indication does not appear when the unit is powered off.)

Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and CD-RW that have been finalized§ upon completion of recording. It may not be able to play some CD-R or CD-RW due to the condition of the recording.
§

Finalizing is a process that enables CD-R/CD-RW players to play audio CD-R and CD-RW.

4