|
|
|
Kto jest w sklepie?
Sklep przegląda 5560 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
;
Instrukcja Serwisowa jest kompletna i czytelna. Dziękuję!
Dimensions Approx. 355 � 96 � 285 mm (w/h/d): (ED1) Approx. 430 � 100 � 286 mm (w/h/d): (ED4/ED7/ED8) including projecting parts and controls Mass Approx. 3.7 kg: (ED1) Approx. 4.2 kg: (ED4/ED7/ED8) Supplied accessories Remote commander (1) R6 (size AA) batteries (2) 75-ohm coaxial cable with F-type connectors (1) Plug adaptor (1) (ED1/ED4/ED8) Design and specifications are subject to change without notice.
� Feature Difference SLVFEATURE HEAD/CH RCA REAR LINE IN/OUT RCA FRONT LINE IN CLICK SHUTTLE REMOTE COMMANDER RMTED1PL 2/2 ®/® G G V248 ED4PL 4/4 ®/® G G V248 ED7KR 4/6 ED8PL 4/6
®(3P)/®(3P) ®(3P)/®(3P) ®(3P) ®(3P) G V247B ® V247B
SAFETY CHECK-OUT
After correcting the original service problem, perform the following safety checks before releasing the set to the customer: 1. Check the area of your repair for unsoldered or poorly-soldered connections. Check the entire board surface for solder splashes and bridges. 2. Check the interboard wiring to ensure that no wires are �pinched� or contact high-wattage resistors. 3. Look for unauthorized replacement parts, particularly transistors, that were installed during a previous repair. Point them out to the customer and recommend their replacement.
SAFETY-RELATED COMPONENT WARNING!! COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
4. Look for parts which, though functioning, show obvious signs of deterioration. Point them out to the customer and recommend their replacement. 5. Check the B+ voltage to see it is at the values specified.
�2�
|
|
|
> |
|
