SONY SLVM20HF
Instrukcja Serwisowa

SECTION 2 DISASSEMBLY
NOTE: Follow the disassembly procedure in the numerical order given.

SLV-M20HF

2-1. UPPER CASE, FRONT PANEL BLOCK ASSEMBLY
1 Screws (case)

Upper case

3 Connector From CN423 on MA-335 board 2 4 Hooks 1 Screws (case) 3 Flat cable From CN162 on MA-335 board

5 Front panel block assembly 4 Hooks 4 Hooks

2-2. FR-139, DM-81, AJ-2, AN-17 BOARDS
6 Screw (B2.6 � 8) 5 Antenna (large) shield plate <Note> 7 JK ground plate 1 Screws (B2.6 � 8) 3 Flat cable 2 FR-139 board

From CN140 on FR-139 board
9 AN-17 board 4 Screw (B2.6 � 8) 8 AJ-2 board

1 Screws (B2.6 � 8)

2 DM-81 board

Front panel assembly

3 Frexible board From CN441 on DM-81 board
1 Screws

Note : When peeling off the antenna (large) shield plate, be sure to apply it to the original position on the AJ-2 board. If not so, the resonance level of AN-17 board becomes small.

2-3. MG-21 BOARD, REAR PANEL

4 Hooks 4 Hooks

4 Hooks 2 MG-21 board 5 Rear panel

4 Hooks 3 Release cable stopper from rear panel

2-1