NOTE: In most operating menu modes the last segment of line 2 of the display will show an "X" for EXIT (a sample screen is shown below - fig 10). Choosing (highlighting) this position in the display and pressing the Select button (see below) will "EXIT" back to the previous menu or out of the particular menu or mode completely depending on where within the menu structure you are at the time. A more detailed explanation is given below in the section on menu control buttons.
In order to fully enjoy the capabilities of the SP1 you or your dealer must first set-up and calibrate the SP1.This is a critical step in insuring that all your loudspeakers are properly designated within the unit and that all levels and delays are properly set. To accomplish this process the following tools are needed: Tape measure or other means of determining the distance of each speaker from the chosen listening positions. Sound Level Meter - This device insures that all loudspeaker levels are precisely matched and set accurately.This step cannot accurately be done by ear, a test instrument should be used to ensure proper calibration. (The Radio Shack Analog SPL meter is inexpensive and eminently suitable for this task. Your dealer may have one.) PLEASE NOTE: If for any reason you are not sure that you can accomplish this calibration task or have any doubts as to how it should be done, please contact your dealer or Bryston technical support BEFORE attempting this process. Most Bryston Dealers can provide this service. Please contact your dealer for their policies and procedures in this regard.
Figure 10: Highlight "X" to EXIT
Explanation of �Saved Settings per Source� Feature
The SP1 will now remember different mode settings for each source. Every time a source is switched it will save the following settings before switching to the new source: Digital Status Listening Mode (DigitalAuto, Pro Logic, Stereo, Mono, or Music) THX Status Bypass Status Subwoofer Level Rear Channel Levels Xbass Setting Speaker Configuration Note1: You must set the speaker configuration manually for each input, within the LCD setup menu. Note2: The Test Noise mode will overwrite Rear and Sub level settings for ALL inputs.
