JVC SP-DWF10
Instrukcja Serwisowa

3.6

Removing the net assembly (See Fig 7)

(1) From side of the main body, insert the tip of the flat-bladed screwdriver or similar tool into the space between the main body and net assembly, and lift the net assembly little by little to remove. (See Fig 7) Note: To prevent damaging the net assembly and main body, insert cushioning plates etc. and below the tip of the flat-bladed screwdriver or similar tool. From right side of the main body, release the eight joints d, and take out the net assembly from the main body. (See Fig 7)

Flat-bladed screwdriver,etc. Net assembly Cushioning plate,etc.

Main body Fig.7
3.7 Removing the speaker. (See Fig 8 and Fig 9)

� Prior to performing the following procedures, remove the net assembly. (1) Remove the six screws H attaching the speaker. (Fig 8) (2) Take out the speaker from the main body. (3) Disconnect the wires from the terminal of the speaker. (See Fig 9)

Joint d (eight joints)

H H

Fig.8

Terminal Main body
Fig.9

Speaker

1-8 (No.MB251)