Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 19 (kliknij aby zobaczyć)
Connections
Before connecting this unit to the amplifier (or receiver), observe the following carefully. � Turn off the amplifier. � Make all connections before plugging in this unit.
� DO NOT connect this unit to the REC OUT jacks of your amplifier. It may damage your subwoofer.
Monaural audio cord (Supplied) Amplifier or Receiver
To LINE OUT
To SUBWOOFER OUT or MONO
To an AC outlet Stereo audio cord (not Supplied) In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal.
Operations
Front Rear
Power lamp
Turning On the Power�POWER
To turn on the power. Press the POWER switch to the [ � ] ON position. � The power lamp lights in green.
Operating the Unit Automatically According to the Incoming Signals�AUTO POWER ON/STANDBY
To activate AUTO POWER ON/STANDBY. Press the AUTO POWER ON/STANDBY switch to the [ position. � If no sound comes in for 5-10 minutes, the unit enters standby mode. The power lamp lights in red. � If the unit detects incoming signals, the unit starts operating. The power lamp lights in green. ] ON
To cut of the power. Press the POWER switch to the [ � ] OFF position. � The power lamp goes out. � This will disconnect the mains lead.
To cancel AUTO POWER ON/STANDBY. Press out the AUTO POWER ON/STANDBY switch to set it to the [ ] CANCEL position.
AUTO POWER ON / STANDBY
ON CANCEL
When the volume level of the amplifier is so low or the incoming signals are so weak that this unit cannot detect sounds, Auto Power On/Standby may not work correctly.
