Eject Disc
This setting controls the ejection of the discs by the CD writers. Three options are available: �Always� means the CD writers will always eject the CD discs no matter whether duplication is successful or has failed. �No� means all discs will remain in the CD writers when the job is done. You will then need to eject the discs from the CD writers manually. The �Pass� setting will only eject the passed discs automatically and leave the failed discs in the CD writers. Press the �Status� switch to eject those failed CDs. Press the �Status� button to change the setting and the �Start� button to exit.
Buzzer
This setting controls the ON and OFF function of the system buzzer. The default setting is �On�. Press the �Status� button to change the setting and the �Start� button to exit.
CD + G
This setting activates the duplication capability of the CD+G format. The Default setting is �No�. Press the �Status� button to change the setting and the �Start� button to exit.
Copy Comp Eject
This setting controls the ejection of the CD writers under the �Copy + Compare� function. If the setting is �Yes�, the trays will eject the recorded discs after duplicating. The system will re-insert the same discs again for subsequent comparison. If the setting is �No�, the writers will not be ejected between Copy and Compare. The default setting is �Auto� which means the ejection of the writers will take place after the initial duplication. Press the �Status� button to change the setting and the �Start� button to exit.
Skip Read Error
This setting controls error skipping during source reading. The default setting is �No�. When an error is detected during the load or read in process, the duplicator will stop the read in or load and display a �Read Error� message. If the setting is �Yes�, there will be no message shown even if there is an error in reading. You can use this function to copy source CD�s with errors. Press the �Status� button to change the setting and the �Start� button to exit.
Mode 2 Compare
This setting can be activated to compare a source data format stored in a �MODE 2� source disc. The default setting is �No�. Press the �Status� button to change the setting and the �Start� button to exit.
Startup Command
This setting specifies the first function the Spinwise Tower will perform when initially powered up. This allows the user to avoid the repeated selection of this function as the unit is turned on. Press the �Status� button to change the setting and the �Start� button to exit.
Read CD DA Index 0
This setting controls the duplication of audio data existing in index 0. �Yes� will copy the index 0 data and �No� will leave it blank. Press the �Status� button to change the setting and the �Start� button to exit.
