Front panel features
(See page 108 ) q POWER switch When this switch is pressed once, the power turns ON and display appear on the display panel. When pressed again, the power turns OFF. After initialization or resetting, press this switch to enter the standby mode. To turn the power ON, press any of the function buttons of the main unit or the POWER button of the remote control unit. w SPEAKERS (ON-OFF) button Use this button to select speaker system ON or OFF e PHONES socket for stereo headphones This jack is compatible with a wide range of conventional dynamic headphone types. NOTE: Change the surround mode to STEREO when using the headphones. r Tuning/Preset UP/DOWN, F/P(frequency/preset) buttons During AM or FM reception, you can scan to other frequencies or preset number by pressing these buttons. t FM MODE button Press this button to select stereo or monaural mode, when listening to FM broadcasts. y MEMORY button Press this button to memorize the desired station frequency. Please see Page 9 for a detailed usage. u BASS CONTROL knob Adjust the low frequency level with this control according to your taste and room acoustics. i TREBLE CONTROL knob Adjust the high frequency level with this control according to your taste and room acoustics. o BALANCE CONTROL knob Adjust the sound volume between left and right front speakers with this control knob. !0 VCR2 audio/video input jacks Connect the audio/video output of the second VCR, etc. to these IN jacks. !1 Input selector button This button selects the audio or audio/video source. The selected source name will be displayed on FTD. Pushing this button in the standby mode, allows to turn the power ON. !2 SET button When speaker mode is decided, this button is pushed. !3 Mid night button (for Dolby digital, Digital Down mix mode only) The source with large dynamic range is compressed. !4 6-CH INPUT button When selecting to other surround processor and/or equipment (example MPEG2), this button is pushed. SR5OOO enters the state which can be controlled to the input of 6 channels even if any state. All the displays concerning surround mode are off. SR5OOO returns to former state when 6 channel direct is made off. !5 REMOTE SENSOR This SENSOR receives the signals from the remote control unit. !6 SPEAKER MODE button Adjusting the settings of the center ,surround and sub woofer speaker mode as follows. The setting of the main speakers can be switched between LARGE � SMALL except in case �e� below. Press the speaker mode button: a.When DTS mode: Center speaker LARGE � SMALL � NONE When the selection is finished, SET button is pushed, then display changes to surround speaker mode Surround speaker LARGE � SMALL � NONE When the selection is finished, SET button is pushed.Then displayed changes to sub woofer ON or OFF Sub woofer: ON � OFF When the selection is finished, SET button is pushed. The display returns to the origin. b.When Dolby Digital mode: Center speaker LARGE � SMALL � NONE When the selection is finished, SET button is pushed. Then displayed change to surround speaker mode Surround speaker LARGE � SMALL � NONE When the selection is finished, SET button is pushed.Then displayed change to sub woofer ON or OFF Sub woofer: ON � OFF When the selection is finished, SET button is pushed. The display returns to the origin.
c.When Pro-Logic mode:
Center speaker LARGE � SMALL � NONE When the selection is finished, SET button is pushed. Then displayed change to sub woofer ON or OFF Sub woofer: ON � OFF When the selection is finished, SET button is pushed. The display returns to the origin. d.When 3-Stereo mode: Center speaker LARGE � SMALL When the selection is finished, SET button is pushed. Then displayed change to sub woofer ON or OFF Sub woofer: ON � OFF When the selection is finished, SET button is pushed. The display returns to the origin. e.Other surround, stereo mode Sub woofer: ON � OFF When the selection is finished, SET button is pushed. The display returns to the origin. Mode of center/surround and sub woofer mode is memorized. !7 MASTER VOLUME CONTROL Adjust the overall sound volume from the front, center, (sub woofer) and rear speakers with this control. Pre-Out (front, rear, center, sub woofer) can also be controlled. !8 RDS Functions a. SEARCH button This key is used to search a station broadcasting, TP or PTY data by scanning. Press the DISPLAY Button then press the SEARCH button. Now �RDS� is displayed, each further press of the SEARCH button changes the display as shown below. TP / PTY / FREQUENCY When the desired item is displayed, press the TUNING UP or DOWN button to start scanning. b. DISPLAY button Each press of this button changes the display contents as shown below. FREQUENCY / STATION NAME / PROGRAM NAME / TIME(CLOCK) / TEXT / FREQUENCY However, the above is not displayed when there is no RDS data with the station being received. c. PTY (PROGRAM TYPE)SELECT button When �PTY� is selected with the SEARCH button, select the desired program type by pressing the PTY SELECT button. When the desired program type is displayed, press the TUNING UP or DOWN button to start scanning. !9 SURROUND MODE knob Surround mode changes as follows whenever you adjust this knob. For the digital equipment: CD, LD, DVD. (when selected optical or coaxial input) DTS Dolby Digital PRO-LOGIC 3 STEREO
CHURCH STADIUM HALL THEATER
For the digital equipment: CD, LD, DVD. (when selected analog input) PRO-LOGIC 3 STEREO THEATER HALL
CHURCH STADIUM
For the analog equipment: TUNER(AM/FM), TAPE-1, TAPE-2, VCR PRO-LOGIC 3 STEREO THEATER HALL
CHURCH STADIUM
@0 STEREO(SURROUND OFF) button When switching from surround mode to stereo mode, this button is pushed. When Dolby digital mode, This Button operates as down mix (2 channel) function and FTD�s �STEREO�indicator is light up. @1 DIGITAL SELECT. button Push this button to switch the digital signal (When CD, LD, DVD. selected) When CD function a. DTS mode Optical / Coaxial-1 / Coaxial-2 b. Stereo, Pro logic, 3 Stereo, Other surround (Hall etc.) mode Optical / Coaxial-1 / Coaxial-2 / Analog(Digital off) When DVD. function a. DTS, Dolby Digital mode Optical / Coaxial-1 / Coaxial-2 b. Stereo, Pro logic, 3 Stereo, Other surround (Hall etc.) mode Optical / Coaxial-1 / Coaxial-2 / OFF (analog) When LD/TV function a. Dolby Digital, mode Optical / Coaxial-1 / Coaxial-2 b. DTS mode Optical / Coaxial-1 / Coaxial-2 c. Stereo mode Optical / CoaxiaI-1 / Coaxial-2 / Analog d. Dolby Pro logic, 3 Stereo, Other surround Optical / CoaxiaI-1 / CoaxiaI-2 / Analog
