WHIRLPOOL SRD325S5W
Instrukcja Obsługi

Care and Cleaning
WARNING
To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before cleaning. After cleaning, reconnect power.

Condenser Coil
Clean condenser coil every three months. Accumulated dust and lint may cause the following: � reduced cooling performance � increased energy usage � premature part failure 1. Remove toe grille by pulling forward. 2. Clean coil with a vacuum cleaner hose nozzle. 3. Replace toe grille by inserting clips in holes and snapping in. 4. Pull refrigerator away from wall. Run a vacuum brush across condenser fan outlet grille on back of refrigerator.

Caution
To avoid personal injury or property damage, read and follow all cleaning product manufacturer's directions.

General
� Wash surfaces with four tablespoons baking soda diluted in one quart warm water and a soft, clean cloth. � Rinse surfaces with warm water. Dry surfaces with a soft, clean cloth. Important � Do not use the following items: - abrasive cleaners such as ammonia, chlorine bleach, etc. - solvents - metal scouring pads These items can scratch, crack and discolor, surfaces. � Do not place refrigerator shelves or accessories in dishwasher.

Glass Shelves Caution
To avoid personal injury or property damage, handle tempered glass shelves carefully. Shelves may break suddenly if nicked, scratched, or exposed to sudden temperature change. Remove shelf and place on a towel. Allow shelf to adjust to room temperature before cleaning. Clean crevices by doing the following: 1. Dilute mild detergent and brush solution into crevices using a plastic bristle brush. Let set for five minutes. 2. Spray warm water into crevices using faucet spray attachment. 3. Dry shelf thoroughly and replace.

Adhesives
Remove glue residue by dabbing toothpaste over adhesive. Rub toothpaste into adhesive with fingers until adhesive loosens. Rinse surface with warm water. dry surface with a soft, clean cloth.

Light Bulbs Door Gaskets
1. Clean door gaskets every three months according to "General" cleaning instructions. 2. Rinse and dry gaskets thoroughly. 3. Apply a light film of petroleum jelly to keep door gaskets pliable.

WARNING
To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before replacing light bulb. After replacing light bulb, reconnect power.

Caution
To avoid personal injury or property damage, observe the following: 1. Allow bulb to cool. 2. Wear gloves when replacing light bulb. Remove light bulb cover. Replace light bulb with same size and type of appliance bulb.

10