STANTON ST150
Instrukcja Obsługi

PART NAMES & FUNCTIONS
22 21 20 19 18

the stylus onto the record as it may cause damage to the diamond tip and to the record. 14) PITCH ON/OFF The ON setting will allow use of the pitch adjust. When set of OFF, the pitch control will be locked at 0%.
16 15 14

1

17

15) TONE ARM BASE The tone arm base includes the height adjustment and tone arm rest. See ìtone arm and cartridge settingsî for proper adjustments. 16) ANTI SKATE KNOB When a record is playing, a force is generated drawing the stylus towards the center of the record. Set this knob to the same value as the stylus pressure to offset this force. 17) COUNTERWEIGHT Use this to balance the tone arm and to adjust the stylus pressure. See ìtone arm and cartridge settingsî for proper adjustments. 18) LINE OUT L & R This is the standard analog output (RCA jacks) which can be connected either to a phono or line input on any DJ mixer, depending on the setting of the phono / line selector. Note: Key lock processing is only available when the LINE output is used. 19) PHONO/LINE SWITCH Note: Key lock and Digital output processing is only available when the LINE output is used. 20) DIGITAL OUT Use this output to connect your ST-150 to any SPDIF in equipped digital device such as a CD-R or Computer. 21) POWER CORD CONNECTOR Used to connect the included power cord. 22) POWER SWITCH This switch turns the power on or off, including the motor and audio signal.

2

13 12

3 11 1

4

5

6

7

8

9 10

1) START/STOP Press this button to start or stop the platter. 2) STROBE DOTS The dots around the edge of the platter are used in conjunction with the light located inside the motor ON/OFF switch. While the platter is in rotation, the dots help to indicate the speed of rotation. The speed is lower than the displayed speed (33,45,78) when the dots are flowing to the right. It is higher than the displayed speed (33,45,78) when the dots are flowing to the left. When the strobe is stopped, the platter is rotating at the displayed speed. 3) MOTOR ON/OFF SWITCH As opposed to fully analog turntables, this is not the power switch. This switch only turns on or off the motor. Rotate clockwise to turn on the motor. The platter will not start spinning until the start/stop button has been pressed. Rotate counter-clockwise during playback (off position) for a slow winding down effect. 4) PLATTER REVOLUTION SPEEDS (rpm) 33 rpm - Press 33 45 rpm - Press 45 78 rpm - Press 33 and 45 buttons simultaneously. To return to 33 or 45-rpm play mode, just press the desired button. 5) TARGET LIGHT Insert target light to the deck and it will light up..

6) START The Start time is adjustable from 0.2~6 sec. 7) BRAKE The Brake time is adjustable from 0.2~6 sec. 8) REVERSE This button is used to reverse the direction of the platter rotation. 9) KEY LOCK Press to enable key lock. When key lock is on, the pitch slider will only affect the speed of the platter. The key (tone) will remain at 0% Note: Key lock processing is only available when the LINE output is used. 10) PITCH SELECT Press the button to switch between +/-8%, +/-25%, or +/-50% pitch range. 11) HEADSHELL LOCKING NUT Attach the headshell by inserting into the front end of the tone arm. Turn the locking nut clockwise with the head shell firmly held horizontally. 12) PITCH SLIDER The pitch slider is used to speed up or slow down the turntable platter. 13) TONE ARM This is a fully manual tone arm. To start playback, gently place the stylus on the record using the headshell finger support. Do not drop