1 Connect the DC Input Lead to the [DC IN 4.9V] socket on
1
DC IN 4.9V
the SD Mobile Printer. 2 Connect the AC Main Lead to the AC Adaptor and the AC outlet.
�Hold down the Power Button [ printer is turned on. ] for about 2 seconds, and the
The SOCKET OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.
2
ª
Using the Battery
1 Attach the Battery 1 to the Battery Holder on the SD
Mobile Printer and slide it forward until it locks with a click. 2 Connect the AC Main Lead to the AC Adaptor and to an AC Outlet. (Refer to the description above.)
�The [
Using the Battery
] Lamp flashes.
3 Leave them as above until the Power Lamp [
off.
DC IN 4.9V
] goes
1 2
1
�When recharging is completed, the [ ] Lamp goes OFF. �Remove the AC Adaptor to use the Battery.
Ejecting the Battery
Press and hold 1 the claw 2 toward the direction shown by the arrow and slide the battery to eject 2.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer�s instructions.
2
1
�It takes about 100 minutes, maximum for full-charging. (at a temperature of 20°C and humidity 60%) If the Battery is charged at a higher or lower temperature, the charging time may be longer. �When recharging, turn the power of the printer OFF. �If the [ERROR] Lamp lights or flashes during recharging, recharging is not normal. Refer to �Error Lamp� on page 22. �Remove the battery if the printer is left unused for a long time. �Full charge of the battery enables you to print near up to 45 sheets continuously at ambient temperature.
