PIONEER S-W1EX/MLXTW1
Instrukcja Obsługi

5 Volume knob (VOLUME) Sets the subwoofer volume. � Turn the knob slowly from the MIN position. � With this unit, the bass level can be independently set, so do not turn up the bass on the stereo or AV amplifier.
S-W1EX Music mode Frequency response
100 90 80 70 60
Sound pressure level
Bypass

(dB)

6 Line Level Input terminal (LINE LEVEL INPUT) Connects to the stereo amplifier�s SUBWOOFER PREOUT terminal, with the specially provided RCA plug cord. 7 Line Level Output terminal (LINE LEVEL OUTPUT) Used for connecting other equipment through the amplifier. The signal output from this jack is not affected in any way by the settings of the various controls on the unit. 8 Phase switch (PHASE 0º /180º ) When set to 180º the output phase becomes the reverse of the input signal, and when set to 0º it is in the same phase as the input signal. � Normally, the switch is set to 0º. But when the sound connection between the subwoofer and the left and right speakers sounds unnatural, try switching to 180º � When using two or more subwoofers together, make sure that the phase switch of all of them are set to the same position. 9 Earth terminal See Connecting the signal ground terminal on page 8. 0 Speaker Level Input terminals (SPEAKER LEVEL INPUT) Connect to the speakers output terminals on the stereo amplifier, using speaker cords (not supplied). - Power supply cable connector Connect the accessory power supply cable here.

50 40 10

Non-bypass (Crossover 150Hz)

100

1000
Frequency (Hz)

10000

REAR PANEL
8 76 0

9

-

CONNECTIONS
Before making or changing any connections, switch off the power and disconnect both this unit and the amplifier/receiver from the AC outlet.

LINE LEVEL CONNECTION (�) �
S-W1EX(Rear Panel) Supplied RCA plug cord
SUB WOOFER PREOUT

This connection is for a stereo amplifier or receiver equipped with a SUBWOOFER PRE-OUT terminal. If the stereo amplifier or receiver is not equipped with a SUBWOOFER PRE-OUT terminal, carry out a Speaker Level connection. Connect to the LINE LEVEL INPUT terminal on this unit, using the specially provided RCA plug cord.

NOTES: � When connected to the PRE-OUT terminal for surround center channel on the stereo amplifier or receiver, the bass is heard only on the center channel, so it will be insufficient.

6
En