PIONEER S-W80S/MLXTW
Instrukcja Serwisowa

S-W80S

7. GENERAL INFORMATION
7.1 DISASSEMBLY
Removing the Amplifier Assy
1 ) The Amplifier Assy is attached to the cabinet by 4 external screw 1. To detach it, pull down the subwoofer toward the left side. Then unfasten those screws 1 (� 4) 3 ) The SW. Assy and LED ASSY is attached to the front panel by each 2 screws. To detach them, remove the Amplifier Assy first. Then unfasten each screws from the cabinet back side.

Be sure to bind the POWER SW lead and LED lead by the cable holder(twist-lock).

LED ASSY SW. ASSY

Screw1

2 ) Stand up the speaker again. After unfastening the rear panel screw 2 (� 8), pull straight the Amplifier Assy toward back about 13cm. Then remove the connecting cord of SW. Assy and LED Assy. Next, pull out the Amplifier Assy and remove the speaker cords.
2 2 2 2

Bind the SP lead by the binder.

Removing the Subwoofer
1 ) The speaker element is attached to the back board by 4 external screws 3 and washers. To detach it, unfasten those screws and washers. 2 ) When attaching the speaker, face its terminal downward. (Screws must be used with washers.)
LINE LEVEL
INPUT OUTPUT

SPEAKER LEVEL

R

L
OUTPUT

2
INPUT

2
+ -+

3

3

2

2
Rear Panel

3
Bind the Power SW lead Amplifier Assy and LED lead by the binder.

3

Be sure to fix the lead between CNTL-ASSY and POWER ASSY to the chassis by the binder.

50

Hz

200

LINE LEVEL
INPUT OUTPUT

SPEAKER LEVEL

R

L
OUTPUT

INPUT

+

-

-+

Removing the Front Panel
The front panel is attached to the baffle by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side.

Be sure to bind the secondary side lead of the transformer by the binder.

17