JVC SX-WD10J
Instrukcja Obsługi

English

Thank you for purchasing JVC speaker. Before you begin using the speaker, please read the instructions carefully.

Preparation
o Attaching the feet
To prevent the speaker from falling over, be sure to attach the supplied feet to the speaker. � Take care not to drop the feet or speaker while assembling; otherwise, it may cause damage to the �oor or injury. � Ensure enough space for assembly and installation. � Place a large, thick cloth on the �oor where you assemble the speaker, so you can protect the �oor and the speaker itself. � Do not touch the speaker units.
1. Turn the speaker upside down.

Warnings, Cautions and Others
o Precautions for installation
� Do not install the speakers on an uneven surface or in a place subject to vibration; otherwise, they may fall over, causing damage or injury. � Take the occurrence of earthquakes or other physical shocks into consideration when selecting the installation place, and secure the speakers thoroughly. � To prevent deformation or discoloration of the cabinet, do not install the speakers where they are exposed to direct sunlight or high humidity, and avoid installation near air conditioning outlets. � Speaker vibrations may cause howling. Place the speakers as far away from the player as possible. � The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers. � When placing the speakers near a TV set, turn off the TV�s main power switch or unplug it before installing the speakers. Then wait at least 30 minutes before turning on the TV�s main power switch again. Some TVs may still be affected even though you have followed the above. If this happens, move the speakers further away from the TV. � Tuner reception may become noisy or hissing if a speaker is installed near the tuner. In this case, leave more distance between the tuner and the speakers or use an outdoor antenna for better tuner reception without interference from the speakers. � Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.

� Turn the speaker and facing the bottom upward. Caution: Make sure the speaker does not fall.

Speaker units

2.

Attach the feet. Foot x 3 Tighten Insert

� Attaching the 3 feet on the bottom of the speaker.

o Precautions for daily use
� To maintain the appearance of the speakers � Wipe with a dry, soft cloth if the cabinet should become dirty. If very dirty, wipe with a cloth applied a small amount of water or neutral detergent, then wipe with a dry cloth. � Do not use chemicals such as benzene and thinner for cleaning the cabinet. � To improve the sound �eld � It is recommended to leave a space of more than 50 cm between the speakers and the wall. � If the speakers are facing a solid wall or glass door, etc., it is recommended to furnish the wall with materials that absorb sounds, for example by hanging up thick curtains, to prevent re�ections and standing waves. � To use the speakers without any trouble � Do not reproduce sounds at so high a volume that they are distorted; otherwise, the speakers may be damaged by internal heat buildup. � When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury. Speaker section
3. Attach the base.

� Prepare a Philips screwdriver. � Attaching the base securely on the feet with the supplied three screws. Screw x 3 (M8 x 40 mm)

Base Face the surface with the countersunk holes upward.

Speaker section

2