Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 19 (kliknij aby zobaczyć)
Adjusting the level of the received audio signal
You can adjust the level of the received audio signal (e.g. the voice of the speaker) in 64 steps. Use the / rocker button (UP/DOWN) to adjust the level of the received audio signal so that you can hear the speaker loud and clear.
Adjusting the level of the internal microphone
You can adjust the level of the internal microphone (via which you can hear environmental sounds) in 64 steps. Press the SET button Use the level. / . The current level is displayed. to adjust a comfortable rocker button (UP/DOWN)
Note: You can only adjust the level of the internal microphone when the internal microphone is switched on in the receiver�s configuration. If, in addition, the automatic priority circuit is switched on, the internal microphone is faded out as soon as speech is being transmitted.
Switching the channel
You can only switch between the released channels. This can be necessary when the selected channel is subject to interference. Always set the receiver to the same channel as the transmitter. If interference occurs, check if the same frequency is assigned to the same channel on both transmitter and receiver. Press the SET button and keep it pressed for approx. five seconds. The current channel is displayed. Use the / rocker button (UP/DOWN) to select a channel.
