Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 19 (kliknij aby zobaczyć)
Cleaning the moisture sensor
Occasionally the moisture sensor has to be cleaned because a fine layer of transparent buildup is deposited on the sensors.
Changing the light bulb
The dryer light turns on inside the drum when you open the door. To change the light bulb: 1. Turn off the circuit breaker. 2. Pull out power supply plug. 3. Open the door and locate the light bulb on the upper center of the seal.
7. Clean the air cooler completely, drain thoroughly. 8. Clean the seals.
9. Re insert the air cooler, handle at the bottom! 10. Unscrew both locking levers. This deposit can easily be removed by wiping the sensors (the two bars next to the lint filter) with a cloth and a little white vinegar. Use white vinegar only! Clean the moisture sensor once a month.
4. Loosen the screw of the cover and open the cover. 5. Turn bulb counterclockwise. Replace the bulb with a new appliance bulb only (obtainable through customer service). 6. Replace the cover and secure with the screw. 7. Plug in dryer or reconnect power supply.
11. Close the maintenance flap until it locks into position.
Cleaning the bearing shield
Over time, fluff from the drying process collects in the bearing shield.
This fluff can be easily removed using your vacuum cleaner, at least once a month.
