Features
A Patented AccuControl System with Removable Guide Comb Attachment B Selected Hair Length Setting Window C 4 Length Settings D 3-Dimensional Rounded Chromium Steel Cutter Blades E On/Off Switch F Cleaning Brush Full Two-Year Warranty 60-Day Money-Back Guarantee Trimming Length Settings Table
Settings
#1 #2 #3 #4 �Stubble� Setting Short Medium Long
Resulting beard length
.06 in./1.5 mm .12 in./3 mm .2 in./5 mm .28 in./7 mm
Trimming For �Stubble� Look 1 Be certain Guide Comb is on Trimmer and use setting #1 to result in a �stubble� look. (fig. 9). Trimming Without Guide Comb Attachment Remove Guide Comb Attachment if you are:
� Defining hair lines � Trimming nape of neck � Removing single, unwanted hairs
1 Be certain Trimmer is in the OFF position. 2 Remove the Guide Comb Attachment by adjusting it to setting #4 and then pulling it off the Trimmer (fig. 10). Never pull off the Guide Comb Attachment by grasping the flexible top portion. Always pull off by the bottom part of attachment. 3 Switch the Trimmer ON. 4 Make well-controlled movements.Touch the hair lightly with the Trimmer (fig. 11). Replacing Guide Comb Attachment On Trimmer 1 Be certain Trimmer is in OFF position. 2 Replace Guide Comb Attachment until it �clicks� into position and adjust comb to the chosen setting.The Guide Comb Attachment can be placed on Trimmer only one way. If it does not fit properly, reverse it.
Cleaning
� Always switch Trimmer OFF before cleaning. � Do not use abrasives, scourers or liquids such
as alcohol, benzene, bleach or acetone to clean the Trimmer. � Never clean, remove or replace Guide Comb Attachment with motor ON. � Do not apply pressure to cutters. � Do not touch cutters with hard objects as this may damage them. � Do not use while bathing, showering or immerse the Trimmer in water or other liquids as damage to Trimmer may occur. During Use:
� If cut hairs have accumulated in the Guide
Comb area, turn Trimmer off, remove the Guide Comb Attachment by adjusting it to setting #4 and then pull it off Trimmer. Remove hairs by shaking and/or blowing. Once A Week: 1 Make sure the Trimmer is switched OFF. 2 Remove the Guide Comb Attachment. 3 Open the cutting unit by pushing it backwards (fig. 12 #1). 4 Clean the cutting unit and the inside of the Trimmer with the brush supplied (fig. 12 #2). 5 Close the cutting unit by pushing it back into place on the Trimmer until you hear a click (fig. 13).
Replacing The Cutting Unit
If your cutters become damaged or worn, do not continue using the Trimmer. Replace cutters immediately. 1 Open the cutting unit. 2 Remove the old cutting unit by pulling it upwards. 3 Place the two notches of the new cutting unit into the guiding slots (fig. 14 #1).
