Operating peripheral equipment using the remote control
Programming the remote control code
You can operate other manufacturers� components using this TV�s remote control. Preparations: � Connect the plug of the external component to the wall outlet. � Make sure the component is turned off.
1
POWER
POWER
+
SAP
VOL
CH
OK
VOL
Press and hold POWER and OK together, for at least 5 seconds. � The mode selection buttons flashes, and then release the POWER and OK.
VC
T V
R
DBS/CB
L
DVD
CH
OK
VOL VOL
V
T
CH
2
RETURN EXIT
VC
R
DBS/CBL
Select the type of the component.
DVD
� The selected button light and all others go out.
CH
MENU
TV/VIDEO
RECALL
MUTE
GUIDE
3
1 4 7
2 5 8 0
3 6 9
1 4
2 5
3 6
Enter the 3-digit infrared code (see pages 27, 28). � Factory default setting : Panasonic � Press POWER to test the operation.
7
R-TUNE
8 0
9
SLEEP PROG
REW
PLAY
FF
Notes: � If the component does not operate with the remote control, repeat the procedure using another code. (Some brands have multiple codes). � If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the programming will fail.
PAUSE
STOP
REC
ASPECT TV/VCR
VCR/DBS CH
To find the code not listed in the index After step 2 above, Press to select the code. � The code starts from the current device. � Press POWER button to test the operation. � Repeat the steps until the component code is found. It may take many attempts before the correct code is found. Press to store the code.
