Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 33 (kliknij aby zobaczyć)
Operating peripheral equipment using the remote control
Programming the remote control code
You can operate other manufacturers� components using this TV�s remote control.
� �
Preparation: Connect the plug of the external component to the wall outlet. Make sure the component is turned off.
POWER
SAP
1
T
POWER
+
VOL
OK
VOL CH
CH
E UT
ASPECT
TV/VIDEO
LIG H
T V
AUX
Press and hold POWER and OK together, for at least 5 seconds.
M
DVD
� The mode selection
buttons flashes, and then release the POWER and OK.
DVD
AUX
VCR
RC
VR
DTV
CBL
DBS
T V
CH OK VOL CH
MENU
2
V
CR
R
C VR
Select the type of the component.
DTV
CBL
� The selected button light
DB S
VOL
and all others go out.
RETURN EXIT
3
RECALL PAGE GUIDE
1 4
2 5 8 0
3 6 9
Enter the 3-digit infrared code (see pages 34-36). Factory default setting :
� �
1 4 7
R-TUNE
2 5 8 0
3 6 9
SLEEP/PROG
7
Panasonic Press POWER to test the operation.
Notes: � If the component does not operate with the remote control, repeat the procedure using another code. (Some brands have multiple codes). � If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the programming will fail.
REW
PLAY
FF
PAUSE
STOP
REC
To find the code not listed in the index
TV/VCR VCR CH OPEN/CLOSE
After step 2 above, Press to select the code. � The code starts from the current device. � Press POWER button to test the operation. � Repeat the steps until the component code is found. It may take many attempts before the correct code is found. Press to store the code.
