Using the remote control
The remote uses two (2) provided AAA batteries. They are easily installed by sliding the cover off the remote�s back, aligning the + and - ends of the batteries, sliding them into place, and then replacing the cover. Caution: When replacing the batteries, be aware that using batteries other than the type provided with the projector may risk severe damage to the remote. When disposing of the batteries, be sure to do so in an environmentally proper manner. To operate, point the remote at the projection screen or at the projector (not at the video device or computer). The range of optimum operation is 0 to 30 feet (9.14m). Press the remote�s Menu button to open the projector�s menu system. Use the arrow buttons to navigate, and the Select button to select features and adjust values in the menus. See page 28 for more info on the menus. The remote also has: � � � � � � � � � Power button to turn the projector on and off (see page 16 for shutdown info) backlight button to light the remote�s buttons in the dark Brightness and Contrast buttons to adjust the image Blank button to display a blank screen instead of the current image (to change the color of the screen, see page 33) Source buttons to switch among sources (to assign a particular source to a source button, see page 32) and a source toggle Resize button to change the Aspect Ratio (see page 29) Auto Image button to resynch the projector to the source Preset button to restore stored settings (see page 30) Overscan button to remove noise in a standard definition television (SDTV) image (page 31)
Troubleshooting the remote
� � Make sure the batteries are installed in the proper orientation and are not dead. Make sure you�re pointing the remote at the projector or the screen, not at the video device or the computer, and are within the remote range of 30 feet (9.14m).
