Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 39 (kliknij aby zobaczyć)
Operating peripheral equipment
Programming the remote control code
You can operate other manufacturers� components using this TV�s remote control. Preparations: � Connect the power cord of the external component to the wall outlet. � Make sure the component is turned off.
C A
CH
1
POWER
+
POWER
- VOL
OK CH
VOL+
Press and hold POWER and OK together, for at least 5 seconds. � The mode selection buttons flashes, and then release POWER and OK.
SAP
LIGHT
TV DTV
TV/VIDEO
VCR RCVR
DVD DBS/CBL
SLEEP
AUX
EXIT
2
DTV
VCR RCVR
DVD DBS/CBL AUX
Select the type of the component. � The selected button lights and all others go out.
PECT AS
FAVORITE
E
M UT
CH
RE
LL
- VOL
MENU
OK
VOL+
3
RETURN
1 4
2 5 8 0
3 6 9
Enter the 3-digit infrared code (see pages 40-42). � Factory default setting : Panasonic � Press POWER to test the operation.
CH
7
1 4 7
R-TUNE
2 5 8 0
3 6 9
PROG
Notes: � If the component does not operate with the remote control, repeat the procedure using another code. (Some brands have multiple codes.) � If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the programming will fail.
REW
PLAY
FF
To find a code not listed in the index
PAUSE
STOP
REC
1
After selecting the type of component (step 2, above)
CH
TV/VCR
DVD/VCR CH
OPEN/CLOSE
- VOL
OK CH
VOL+
Press to select the code. � The code starts from the current device. � Press POWER button to test the operation. � Repeat the steps until the component code is found. It may take many attempts before the correct code is found. Press to store the code.
