Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 55 (kliknij aby zobaczyć)
Audio Menu
You can select digital signal type through the DIGITAL OUT terminal. On the Audio menu, you can set the following:
Language Picture Audio Setting Rating
Setting Menu
You can make the speaker settings according to the size and layout of your speakers. On the Setting menu, you can set the following:
Language Picture Audio Setting Rating
D Digital DTS MP3 CD
Off Off Off Off Next Page
Dynamic Range Off C.Delay 0 ms S.Delay 0 ms Speaker Set LR C LS RS SW
Test Tone
D Digital / DTS: � PCM:
� STREAM:
� Off: MP3: � Off: CD / PCM: � PCM:
Select this when you connect to the DIGITAL OUT terminal to the linear PCM digital input of other audio equipment. Select this when you connect to the digital input of an amplifier to a built-in Dolby Digital or DTS multichannel decoder. Do not out signals in DIGITAL OUT terminal. Do not out signals in DIGITAL OUT terminal. Select this when you connect to the DIGITAL OUT terminal to the linear PCM digital input of other audio equipment. Do not out signals in DIGITAL OUT terminal. Select this when you need to downsample the digital output signal. Select this when you do not need to downsample the digital output signal.
Dynamic Range:You can enjoy a powerful sound at night even at a low volume level when listening to the sound with Dolby Digital. � On: Select this when you want to apply the compression effect fully (useful at midnight.) � Off: Select this when you want to enjoy surround with its full dynamic range (no effect applied.) C.Delay: To register delay time for center speaker�from 0 msec to 5 msec. See �Setting the delay time� on the next page. R.Delay: To register delay time for rear speakers�from 0 msec to 15 msec. See �Setting the delay time� on the next page. Enters Speaker setting sub-menu. See �Speaker setting� on the next page. The test tone menu appears on the TV and the test tone comes out from the speakers in the order. See �Adjusting the Sound� on page 23. � If a disc is not loaded, the test tone does not come out. � If there is a speaker from which no sounds comes out, check the speaker�s connection (see pages 6 and 7.)