TOSHIBA TLP-S10
Instrukcja Obsługi

Basic operations
1 Turn on the power.
Turn on the power by following the instructions in �Turning on the power� p.20 .

5 Projector placement angle adjustments
The placement angle and the height of the projected image can be adjusted by the foot adjuster.

2 Select the language and the lamp power (When using the
first time).
When the projector is used for the first time after purchase, menu for language and lamp power selection and configuration is displayed in English. (If the screen is out of focus, adjust it according to the step 6 .)

q Lift up the front of the projector to the desired angle, then press the foot adjuster release button.
The foot adjuster extends. Release the button to lock the position.

1

q Use the or buttons to select the desired language and press the button.
Message for setup confirmation is displayed in a selected language.

w Using the or button, select Standard or Low and press the button.
The lamp power, if selected, will be toggled without pressing the button. The display automatically disappears in a few seconds.

English ................ English Français .............. French Deutsch .............. German Italiano ................ Italian Español ............... Spanish Português .......... Portuguese ................... Japanese ....... Chinese (simplified) ....... Chinese (traditional) ................... Korean

w Turn the foot adjuster to fine-tune the angle. e To adjust the horizontal angle, use the tilt adjuster.

2 3

To stow the foot adjuster, hold up the projector while pressing the foot adjuster release button, then slowly lower the projector.

6 Adjust the picture size and focus.
q Move the projector back and forth to adjust the screen size. w Use the focusing ring to adjust the focus.

Notes
� When the projector is turned on the next time, the Language and Lamp power menus do not appear upon startup. However, if �Reset all� is executed from the Reset menu p.31 , the Language and Lamp power menus will be displayed the next time when the power is turned on � The language can also be set via the Display setting menu p.30 and Lamp power via the Default setting menu p.30 . � This owner�s manual assumes that English has been selected.

7 Adjusting the volume with the
Notes

buttons

The speaker volume can be adjusted when an audio signal is being input.

3 Place connected device(s) in operating status.
Turn on and boot up connected computers and other devices.

� Note that because of the lamp characteristics, the brightness of the lamp may fluctuate slightly. � A lamp is a consumable supply. If used for extended periods, images will appear dark, and the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on conditions of use.) � The LCD panel is made using extremely advanced technology, but there may be black spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please note that these are not malfunctions. � Although this projector supports a wide range of RGB signals
p.38

4 Select input.
q Press the INPUT button.
A list of inputs appears on the screen.

w Use the buttons to select the desired input, and press the button.
The picture for the selected input is projected.

Computer Y/PB/PR Video S-video

, any resolutions not

supported by the model (XGA or SVGA, depending on the model) will expand or shrink the pictures, and will affect image quality slightly. To view high-quality images, it is recommended that the computer�s external output should be set to the projector�s resolution. � With some models of computer having LCD displays or the like, displaying images simultaneously on the projector and the monitor�s display may cause the images to be shown improperly. If this happens, turn off the computer�s LCD display. For information on how to turn off the LCD display, see the owner�s manual of your computer. � If a signal not supported by the projector is input, the icon will appear. � If a no signal is being input from the connected device, the icon will appear. � If an unavailable operation button is pressed, the icon will appear.

22

23

Operations