Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
Continued
Connecting Other Equipments
You can connect the following equipments to the system: � Audio equipment � used only as an analog playback device. � Audio equipment with an optical digital input terminal � used as a digital recording device. When you connect and use these equipments, refer also to the manuals supplied with them.
To connect audio equipment with an optical digital input terminal
By using both an optical digital cable (not supplied) and an audio cable (not supplied), connect: � Between the optical digital input terminal on the other equipment and the optical digital output terminal on XTUXG66. � Between the audio output jacks on the other equipment and the ANALOG IN jacks.
To connect audio equipment without a digital output terminal
Connect the audio output jacks on the other equipment and the ANALOG IN jacks, using an audio cable (not supplied). Be sure that the plugs of the audio cables and the jacks on the rear panel of the unit are color coded: White plugs and jacks are for left audio signals, and red ones for right audio signals.
� DO NOT connect other equipment while the power is on. � DO NOT plug in any equipment until all connections are complete.
(AC wall outlet) To ANALOG IN XT-UXG66 To DIGITAL OUT
To optical digital input
(AC wall outlet) To ANALOG IN XT-UXG66
To audio output
Protective Plug
Before connecting the other equipment, remove the protective plug from the terminal.
NOW, you can plug in the system and other connected equipment FINALLY!
To audio output on the other equipment
When connecting the AC power cord into a wall outlet, the system switches to standby mode with STANDBY/ON lamp lit red.
� By using audio cable (not supplied), connect between the audio output jacks on the other equipment and the ANALOG IN jacks.
