JVC UX-H300
Instrukcja Obsługi

Using the Timers
There are four timers available�Daily Timer, Recording Timer, Snooze Timer, and Sleep Timer. � Before using these timers, make sure the built-in clock is set correctly (see page 8).

On the remote control ONLY:

1 Press CLOCK/TIMER repeatedly to
select the timer you want to adjust and activate�Daily 1, Daily 2, Daily 3, or Rec.

CLOCK /TIMER

Using Daily Timer and Recording Timer
You can set the timer whether the unit is on or off.

How the Timer actually works
When the on-time comes, the unit automatically turns on (the [timer] indicator flashes and continues flashing while the timer is operating). Then, when the off-time comes, the unit automatically turns off (standby). The timer setting remains in memory until you change it. � When the (timer) and DAILY 1, 2, or 3 indicators are lit on the display, the timer acts as the Daily Timer. Once the timer has been set, it will be activated at the same time and automatically turns off (standby) after 60 minutes everyday until the timer is deactivated. � When the (timer) and the REC indicators are lit on the display, the timer acts as the Recording Timer. After the timer-recording finishes, the details of the setting remain stored but the timer is turned off.

The timer setting and hour indication start flashing on the display. Each time you press the button, the display changes as follows:
Daily 1 Timer
ON DAILY 1

Daily 2 Timer
ON DAILY 2

Daily 3 Timer
ON DAILY 3

Before you start...
When using �TUNER� as the source to play, make sure to select the desired station before turning off the power. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start again from step 1.
REC ON

Rec Timer

Clock setting

Normal indication

2 Set the on-time you want the
unit to turn on.
(1) Press UP or DOWN to set the hour, then press SET. (2) Press UP or DOWN to set the minute, then press SET. If you want to change the time setting, press CANCEL.

UP PRESET GROUP

DOWN PRESET GROUP

SET

� If you are setting the Daily Timer, the source name starts flashing on the display. \ Go to step 4. � If you are setting the Recording Timer, the OFF indicator and hour indication start flashing on the display.

21