|
|
|
Kto jest w sklepie?
Sklep przegląda 5473 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
2.1.7 Removing the power amplifier board / power amplifier sub board / main board / heat sink (See Fig.13 ~ 21) � Prior to performing the following procedure, remove the metal cover, the rear cover, the CD-R mechanism assembly and the rear panel. (1) Disconnect the card wire from connector CN900, CN901, CN933 and CN931 on the main board respectively. (2) Disconnect the wire from connector CN949, CN950 and CN951 on the power supply board. (3) Remove the two screws I on the right side of the body. (4) Move the boards and heat sink assembly upwards and disengage the joint d and the two joints e to release the power amplifier board and the main board from the chassis (Refer toFig.15 , 16). Move the rear part of the board and heat sink assembly to the right side. CAUTION: The wire extending from the lower side of the main board is still connected with the body (Refer to Fig.17). (5) Disconnect the wire from connector CN906 on the lower side of the main board (Refer to Fig.18). 2.1.8 Removing the power amplifier board (See Fig.19 ~ 21) (1) Disconnect the power amplifier board from connector CN941 on the power amplifier sub board. 2.1.9 Removing the power amplifier sub board (See Fig.19 ~ 21) (1) Disconnect the two wires from connector CN944, CN945, CN946 and CN947 on the power amplifier sub board. (2) Remove the two screws J attaching the power amplifier sub board and the heat sink. 2.1.10 Removing the main board (See Fig.19 ~ 21) (1) Disconnect the wires from connector CN944, CN945, CN946 and CN947 on the power amplifier sub board. (2) Remove the two screws K attaching the main board and the heat sink. REFERENCE: The power amplifier board, the power amplifier sub board, the main board and the heat sink can be remove drespectively.
Power supply board CN949
Main board CN900 CN933 CN901
CN950
CN951
CN931
Front panel assembly Fig.14
Main board
Front panel assembly
I
Joint e
Fig.15
I
Heat sink
Front panel assembly CN901 CN900 CN931 CN933 Main board
Power amplifier board Power supply board Fig.13 CN949 / CN950 / CN951 Chassis Fig.16
Joint d
1-10 (No.22036)
|
|
|
> |
|
