jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
3. Top Cover/Under Cover (1) (2) (3) (4) Remove the side cover. (Refer to Section 2-1-2.2) Disconnect one harness from the MEC-13 board. Remove one screw, then remove the six hooks. Remove the top cover in the direction indicated by the arrow.
2-1-3. Replacement of Main Parts
1. Replacement of SE-611 Board (1) Remove the side cover. (Refer to Section 2-1-2.2) (2) Disconnect one harness from the SE-611 board. (3) Remove the two screws, then remove the SE-611 board.
Top cover
Top cover
Hooks Harness MEC-13 board
Hooks
Harness
BVTP 3x12
Roller shaft B Align the mating faces Hole Align the mating faces
BVTP 3x6
SE-611 board
(4) Attach a new SE-611 board in the reverse order of steps (1) to (3). 2. Replacement of MEC-13 Board
Roller shaft A Hole Under cover
(5) Attach the top cover in the reverse order of steps (1) to (4). n When attaching the top cover, make sure to align the mating faces before inserting the roller shafts A and B into each hole.
(1) Remove the side cover. (Refer to Section 2-1-2.2) (2) Remove the top cover and under cover. (Refer to Section 2-1-2.3) (3) Disconnect the five harnesses from the MEC-13 board. (4) Remove the three screws, then remove the MEC-13 board.
BVTP 3x8 Harness Harnesses
Harness
MEC-13 board
Under cover
(5) Attach a new MEC-13 board in the reverse order of steps (1) to (4). 2-2 (E)
UYA-S90SF
